Domino HR Cross Throttle System

The Domino Racing HR Cross Throttle has been the standard on European full-size 2 stroke dirt bikes since 1998. It was OEM for more KTM, Husqvarna, Beta, GasGas, TM and many, many more 2 strokes than ANY other throttle control.

Victor Half Waffle Grip and Rubber Cover sold separately.

The “straight pull” design keeps the cable close to the handlebar and less vulnerable. The cable makes the 90⁰ transition to the throttle tube via a pulley with a brass bushing. This creates far less cable drag than other throttle systems. The housing is aluminum with plastic cover and throttle tube.

The HR Cross Throttle has 1.9⁰ of rotation per mm of cable travel, with a maximum cable pull range of 63mm! This is the standard turn rate for most 85-500cc 2 strokes! Included plastic thread reducer allow direct fitment to throttle cables with 10mm thread (most European models) or 8mm (most Japanese models). A cable adjuster and “old school” cable end boot are also included to fit older models with non-threaded cables.

2 Stroke Models with direct fitment to OEM (stock) throttle cable

Throttle Conversion Kits

Adapt a superior Domino Throttle to YOUR dirt bike!

HR Cross Throttle Spare Parts

Throttle Tube

Includes the HR Cross plastic throttle tube only.

Rubber Cover

Includes the HR Cross Rubber Cover. This rubber cover helps protect the cast aluminum housing and deflects dirt, water and other debris from entering the throttle.

Cap / Cover

Includes the HR Cross plastic throttle cap / cover. This is the cap to access the cable and pulley.

Available on the HR Cross Throttle Spare Parts page.

Conversion Cables

• X-1063 – HR Cross to Mikuni Euro Route (2017+ Carbureted KTM 2 Strokes 125-300)
• X-1064 – HR Cross to Mikuni Japanese Route (2017+ Carbureted KTM 2 Strokes 125-300)
• X-1073 – HR Cross to Keihin Euro Route (older KTM 2 Strokes, Beta/Sherco 2 Strokes, etc)
• X-1074 – HR Cross to Keihin Japanese Route (older KTM 2 Strokes, Beta/Sherco 2 Strokes, etc)

Euro Route – Cable routed between rider and handlebar
Japanese Route – 5.5″ Longer cable routed in front of handlebar (between handlebar and numberplate/headlight